Editing Onto Another Tape.24 - Sony Ruvi CCD-CR1 Operating Instructions Manual

Editing onto another tape
You can save the recorded picture and create your own video program by editing with
any other 0
8 mm,
HI0 Hi8,
VMS
VHS, Svms1 S-VHS, IVIKH VHSC, SfVIKH S-VHSC, H3
Beta max VCR or IX' DV that has video/audio inputs.
Before editing
Connect the camcorder to the VCR using the supplied A/V connecting cable.
Set the input selector on the VCR to LINE, if available.
If your VCR is a stereo type
Connect only the black plug for audio I. (left) on the VCR. With this connection, the
sound is monaural even in stereo models.
Starting editing
Turn off the speaker of the camcorder while editing. Otherwise, picture distortion may
occur.
(D Insert a blank tape (or a tape you want to record over) into the VCR.
(2) Play back the recorded video cartridge on the camcorder until you locate the
point just before where you want to start editing, then press II to set the
camcorder in playback pause mode.
(3) On the VCR, locate the recording start point and set the VCR in recording
pause mode.
(4) hirst press II on the camcorder, and after a few seconds press II on the VCR
when you want to start editing.
To edit more scenes
Repeat steps 2 to 4.
To stop editing
Press ■ on both the camcorder and the VCR.
24