Table of Contents
Advertisement
Editing onto Another Tape
You can create your own video program by editing with any other EJ 8 mm, PIE} Hi8, Vs. VHS,
Sus S-VHS, Vasa VHSC, SVwsia S-VHSC, or 8 Betamax VCR that has video/audio inputs.
Before Editing
Connect the camcorder to the VCR using the supplied A/V connecting cable (p. 36).
Set the input selector on the VCR to LINE, if available.
(1) Set the POWER switch to VTR.
(2) Set EDIT to ON in the menu system (p. 35).
tint
>
v
EXECUTE
(MENU: END
cot:
Signal flow
Starting Editing
Turn down the volume of the camcorder while editing. Otherwise, picture distortion may occur.
(1) Insert a blank tape (or a tape you want to record over) into the VCR and insert your recorded tape
into the camcorder.
(2) Play back the recorded tape on the camcorder until you locate the point where you want to start
editing, then press If to put the camcorder in playback pause mode.
(3) On the VCR, locate the recording start point and put the VCR in recording pause mode.
(4) Press Ion the camcorder and VCR simultaneously to start editing.
To Edit More Scenes
Repeat steps 2 to 4.
To Stop Editing
Press
0 STOP on both the camcorder and VCR.
Use of the EDITSEARCH button
You can play back the tape in the normal/reverse direction by holding down EDITSEARCH during
playback pause mode.
You can also play back still pictures successively at specific intervals by pressing EDITSEARCH
intermittently.
uaass
AL e UO
BuiyriEMm
ade)
sayjouy
OU0
bunipz
ze
37
Advertisement
Table of Contents
