Antenna With Vcr; Hook Up Antenna And Vcr To The Tv - Zenith H2546DT Installation And Operating Manual, Warranty

Hook Up Antenna and VCR to the TV

Connect your off-air antenna and VCR to the Presentation TV
Locate the Antenna/Cable jack on the back of the VCR.
1
Connect the cable that runs from the antenna directly to
2
this jack, according to the diagram to the right.
3
Remove the back of the remote and put in two AAA bat-
teries.
back of
remote
4
Plug in the TV. Do not plug it into a switched outlet. The
Presentation TV is designed to operate on standard cur-
rent, 120-volt 60 Hertz AC. Do not attempt to operate it
on DC Current.
5
Go to page 16 to Auto Program the Presentation TV.
No A/V cables are included with the Zenith Presentation
TV.
Without A/V cables, most VCRs will not play videocas-
settes in stereo sound.
206-3492-O
Antenna
Flat wire
(300 ohm)
TV back
ANTENNA
CABLE
S-VIDEO OUT S-VIDEO IN
R- AUDIO- L
COMPUTER
IN
R- AUDIO- L
VIDEO
AUX IN
M.P.I.
R
AUDIO OUT R- AUDIO- L
COMPUTER
L
AUDIO
Antenna
RF coaxial wire
(75ohm)
TV back
ANTENNA
CABLE
S-VIDEO OUT
S-VIDEO IN
R- AUDIO- L
COMPUTER
IN
R- AUDIO- L
VIDEO AUX IN
M.P.I.
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L
AUDIO
VCR back
VCR back AV panel
output
In
300/75 ohm
switch
3 4
Adapter
Out
Audio
Video
A/V cables
not included
with TV
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Video Audio
A/V cables
not included
with TV
P A G E 9