Antenna With Vcr; Hook Up Antenna And Vcr To The Tv - Zenith Presentation H25D46DT Operating Manual & Warranty

Hook Up Antenna and VCR to the TV

Connect an off-air antenna and VCR to the Presentation TV
1
Locate the Antenna/Cable In jack on the back of the
VCR.
2
Connect the cable that runs from the antenna directly
to this jack, according to one of the diagrams to the
right.
3
Remove the back of the remote and put in two AAA
batteries.
Back of
Remote
4
Plug in the TV. The Presentation TV is designed to
operate on standard current, 120-volt 60 Hertz AC.
Do not attempt to operate it on DC Current.
5
Go to page 21 to Auto Program the Presentation TV.
No A/V cables are included with the Zenith Presentation
TV.
Without A/V cables, most VCRs will not play videocas-
settes in stereo sound.
206-3602
Antenna
Flat Wire
(300 ohm)
TV Back
ANTENNA
CABLE
S-VIDEO OUT
S-VIDEO IN R- AUDIO- L
COMPUTER
IN
R- AUDIO- L
VIDEO AUX IN
M.P.I.
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L
AUDIO
Antenna
RF Coaxial Wire
(75ohm)
TV Back
ANTENNA
CABLE
S-VIDEO OUT
S-VIDEO IN R- AUDIO- L
COMPUTER
IN
R- AUDIO- L
VIDEO AUX IN
M.P.I.
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L
AUDIO
VCR Back
VCR Back AV Panel
output
In
300/75 ohm switch
3 4
Adapter
Out
Video Audio
A/V cables
not included
with TV
VCR Back
VCR back AV panel
output
In
switch
3 4
Out
Video Audio
A/V cables
not included
with TV
P A G E 1 7