Antenna With Vcr; Hook Up Antenna And Vcr To The Tv - Zenith Concierge H20C35DT Installation And Operating Manual, Warranty

Hook Up Antenna and VCR to the TV

Connect an off-air antenna and VCR to the TV
1
Locate the Antenna/Cable jack on the back of the
VCR.
2
Connect the cable that runs from the antenna
directly to this jack, according to the diagram to
the right. As required, make the other connections
as shown to the right.
3
Remove the back of the remote, put in two AA bat-
teries.
4
Plug in the TV. Do not plug it into a switched out-
let. The TV is designed to operate on standard cur-
rent, 120-volt 60 Hertz AC. Do not attempt to oper-
ate it on DC Current.
5
Go to page 12 to Auto Program the TV.
No A/V cables are included with the Zenith TV.
Without A/V cables, most VCRs will not play videocas-
settes in stereo sound.
206-3489-O
back of
remote
Antenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
TV back
ANTENNA
CABLE
VIDEO MATRIX
IN OUT
M.P.I.
R- AUDIO- L
IN
TV back panel
(expanded view)
A/V cables
not included
with TV
Antenna
RF coaxial wire
(75 ohm)
TV back RF coaxial wire
(75 ohm)
not included
TV back
with TV
ANTENNA
CABLE
VIDEO MATRIX
OUT
IN
M.P.I.
R- AUDIO- L
IN
TV back panel
(expanded view)
A/V cables
not included
with TV
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Audio
Video
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Audio
Video
P A G E 9