Antenna - Zenith Presentation H25D46DT Operating Manual & Warranty

Hook Up Your Antenna to the TV
Connect an off-air antenna to the
Presentation TV
1 Locate the Antenna/Cable jack on the back of
the Presentation TV.
2
Connect the cable that runs from the wall
directly to this jack, according to one of the
diagrams at the right.
3
Remove the back of the remote and put in two
AAA batteries.
Back of
Remote
4
Plug in the TV. This Entertainment Machine is
designed to operate on standard current, 120-
volt 60 Hertz AC. Do not attempt to operate it
on DC Current.
5
Go to page 21 to Auto Program the
Presentation TV.
If you have a 75 ohm RF cable, then you
don't need any adapters!
A 300 to 75 ohm adapter is not included with
the Zenith Presentation TV.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
300 TO 75 OHM A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
206-3602

Antenna

Flat wire
(300 ohm)
300/75 ohm
Adapter
COMPUTER
IN
Antenna
COMPUTER
IN
RF Coaxial Wire
(75 ohm)
TV Back
ANTENNA
CABLE
S-VIDEO OUT
S-VIDEO IN
R- AUDIO- L
R- AUDIO- L
VIDEO AUX IN
M.P.I.
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L
AUDIO
TV Back
ANTENNA
CABLE
S-VIDEO OUT
S-VIDEO IN R- AUDIO- L
R- AUDIO- L
VIDEO
AUX IN
M.P.I.
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L
AUDIO
P A G E 1 5