Antenna - Zenith H27H49S Installation Manual

Hook Up an Off Air Antenna
Connect an over the air signal source to the TV
Over the Air Antenna
Locate the Antenna/Cable
1
jack on the back of the TV.
Connect the antenna that
2
runs from the wall directly to
this jack, according to the
connection diagram shown
to the right.
If you have a 75 ohm RF
cable, then you don't need
any adapters!
A 300 to 75 ohm adapter is
not included with the LG TV.
To get digital with only one RF antenna lead, install a signal splitter
1
If there is only one antenna lead
available from the wall antenna
jack, locate the Antenna/Cable
and the Digital Antenna jacks on
the back of the TV.
2 Connect the antenna that runs
from the wall directly to a 75
ohm 2-way signal splitter (not
provided) according to the con-
nection diagram shown to the
right.
3
Connect the two antenna leads
to the TV RF inputs:
Antenna/Cable and Digital
Antenna. This will provide the
same over the air signal to both
the analog and digital RF inputs.
Mini Glossary
2-Way Splitter A device that provides two antenna signals from one antenna lead.
75 ohm The wire that comes from an off-air antenna or cable service provider. Each end
RF Cable looks like a hex shaped nut with a wire sticking through the middle, and it screws
onto the threaded jack on the back of the TV.
300 to (Not shown) A small device that connects a flat two-wire 300 ohm antenna to a 75
75 ohm ohm RF jack. They are usually about an inch long with two screws on one end and a
Adapter round opening with a wire sticking out on the other end.
Page 16
TV Back
ANTE NNA
DIGIT AL
CABL E
C
ANTE NNA
O
M
P
U
T
E
R
I
N
480I
M.P.I.
R L
Y
AUDIO OUT
IN
R
P
R B
L
AUDIO
L
R
L P
R
TV Back Connections Panel
(Expanded View)

Antenna

RF Coaxial Wire
(75ohm)
C ANTEN NA
O
M
P
U
T
E
R
I
N
75 ohm
Signal Splitter
TV Back Connections Panel
Antenna
RF Coaxial Wire
Antenna
(75 ohm)
RF Coaxial Wire
(75 ohm)
TV Back
ANTEN NA
DIGIT AL
CABLE
480I
M.P.I.
L
R
Y
AUDIO OUT
IN
R
P B
R L
AUDIO
L
R
L P
R
(Expanded View)