Table of Contents
Advertisement
TP CHASSIS / TELEVISION
After selecting software (*.bin) to be installed, press AUTO button. In standard use,
the following options are recommended.
After completing the settings, please press "Dis Con" button of the program interface,
then turn TV Power Off/On, press "Connect" button within 1-2 seconds. In this way,
TV goes to ISP mode. Here, a message indicates that Device type has been
recognized. If not connected, root cause of problem should be inspected.
After indicating the location of software correctly from READ section, press "Run"
button to start installation. "Erase" process may take 45 seconds. If this process
takes too short after pressing "Run", it might be suspected that there is a problem.
"Verify" process is a must. If there is an error in writing process, most probably this
will be shown within the first 4-5 seconds; you may press "Stop" button before waiting
for the completion of Verify process.
If the installation is successful, "Pass" message appears.
TV should be delivered to the customer after completing software installation,
performing service menu settings (Eco Mode, Blue Back, OSD selection, Keypad and
TV inputs) depending on TV's features and performing Plug Play. Plug Play is
located in System Configuration under Factory Settings (Service Menu).
If the programme does not run successfully, it might be resulting from the following
conditions:
There might be a problem in cables, converter or tool. Probably, TV does not support
USB memory that we are using. We should format USB memory with FAT32 system
107
September 2011
Advertisement
Table of Contents
