Table of Contents
Advertisement
PAGE
7
WEIDER SPORTING GOODS
IMPORTANT
DURING
THE
FOLLOWING
ASSEMBLY
STEPS,
YOU
WILL
FIND
ASSEMBLY
INSTRUCTIONS SHADED IN BOXES SUCH AS THIS.
THESE ASSEMBLIES HAVE BEEN
DONE
AT
THE
FACTORY
FOR
YOUR
CONVENIENCE.
SEVERAL
OF. THESE
PRE-ASSEMBLED STEPS HAVE ONLY BEEN FASTENED FINGER TIGHT. YOU WILL' BE
INSTRUCTED TO TIGHTEN THESE ASSEMBLIES DURING THE STEP. INSTRUCTIONS.
THE ENTIRE ASSEMBLY IS SHOWN AND WRITTEN OUT SO THAT ALL PARTS
INCLUDED IN THAT ASSEMBLY CAN BE MORE EASILY SEEN.
|
STEP1
FRAME
ASSEMBLY
PART NAME
$0
5/16" FLAT WASHER
51
5/16" NYLON LOCK NUT
53
5/16" X 23/4" HEX HEAD BOLT
55
5116" X 1 1/2" HEX HEAD BOLT
56
5/16"X23/4" CARRIAGE BOLT
$8
5/16" Х 2" HEX HEAD BOLT
17 5/16" X2 1/2" CARRIAGE BOLT
a2 |
80 2" SQUARE PLASTIC INSERT CAP
oa
81 2" SQUARE RUBBER COVER САР
2
83
11/4" SQUARE PLASTIC INSERT CAP
КИЕ
О
Cap the front end of the BASE FRAME (1) with а 2" SQUARE PLASTIC INSERT CAP (80).
О
With the BASE FRAME (1) oriented so the welded plate at the front of the Base will be to the ground when assembled,
fasten the ARM PRESS UPRIGHT (2) fo the front section of the Base with two 5/16" X 2 1/2" CARRIAGE BOLTS (77)
and 5/16" NYLON
LOCK NUTS (51).
Note that the UPRIGHT (2) should tilt back toward the rear of the Base when
assembled.
(0 Select the 2" SQUARE Х 38" LONG REAR BASE TUBE (3).
О
Cap each епа of the REAR BASE TUBE (3) with а 2" SQUARE RUBBER COVER CAP (81).
Position the REAR
BASE TUBE (3) into the "L" bracket of the BASE
FRAME
(1) so the longest section of the REAR
BASE TUBE (3) is to the right (as you face the front of the unit). Bolt up through the Rear Base Tube and Bracket with
5/16" X 2 3/4" CARRIAGE BOLTS (56).
ТО Sit the STEPPER UPRIGHT (4) over the Bolts so the Plate at the top of the Upright slants upward from the back to the
front.
(О Bolt the BASE FRAME (1) and UPRIGHT (4) securely with 5/16" NYLON LOCK NUTS (51).
О
Locate the BASE PULLEY BRACKET (7). (This is a flat plate 2" Х 6" with two holes at one end and a single hole at the
other.) Assemble this Bracket to the right side of the BASE FRAME (1) with two 5/16" X 2 3/4" HEX HEAD BOLTS (53).
Secure with 5/16" FLAT WASHERS (50) and 5/16" NYLON LOCK NUTS (51).
4
-
(0 Cap the епа of the Welded Stopper Tube on the ARM PRESS UPRIGHT (2) with a 1 1/4" SQUARE PLASTIC INSERT
CAP (83).
О
Remove the STATION 1 DECAL (121) from the backing sheet and position the Decal to the front of the ARM PRESS
UPRIGHT (2) below the Welded Stopper Tube.
Advertisement
Table of Contents
