Table of Contents
Advertisement
Ц] Using a 5/16" x 3 1/4" HEX HEAD BOLT (60), insert the Bolt through a 3" LONG "U" PULLEY BRACKET (39) and
fasten the Bracket to the front side of the ARM PRESS UPRIGHT (2) just above the Backrest. "IMPORTANT": This
Bracket must NOT be tightened against the Upright. Fit a "5/16" FLAT WASHER (50) and а "5/16" NYLON LOCK
NUT (51) onto the Bolt and tighten only enough that the Bolt comes through the Nut just a few threads. This will let the
- Bracket Stand away from the Frame about 14 inch. The Bracket must be BENE to pier up and nown:
e
g 1/2" PULLEY (а өз) trap the LAT CABLE E (82) into the ау PULLEY BRACKET e». at the fr
О
то assemble the LAT CABLE (32) into the pre-assembled PULLEY (б), it will be necessary to remove the Pulley by
untightening the 3/8" X 1 3/4" HEX HEX BOLT (65) and 3/8" NYLON LOCK NUT (63) and removing the Pulley. Assemble
the Cable onto the Pulley and re-assemble the Pulley into the "U" PULLEY BRACKET (39).
C] Assemble the 88" WEIGHT
STACK CABLE (40) to the
SELECTOR
TUBE
(11).
First, be sure that the Metal
Adjuster
Ferrule
and
Rubber
Stopper
Ball are
positioned to the end of the
Cable
so
the
Adjuster
Ferrule is between the Ball
and the loop end of the
Cable.
Insert the other loop
end. of the Cable
into the
end of the Selector Tube.
Position
the
molded
PLASTIC
GUIDE
BRACKET
(41) so it fits
behind the Selector -Tube
and in front of the GUIDE
RODS (9).
(0 Bot
through
the
SELECTOR
TUBE
(11),
CABLE
(40)
end,
and
GUIDE BRACKET (41) with
а 5/16"
X 1 1/2"
HEX
HEAD
BOLT
(55) and a
5/16" NYLON LOCK NUT
(51).
Advertisement
Table of Contents
