Yamaha SPX2000 Owner's Manual page 70

■Fine parameters
Parameter name
MIX BAL.
OUT LVL
HPF Thru, 21.2 Hz—8.00 kHz
LPF 50.0 Hz—16.0 kHz, Thru
REV/FLG
REV.BAL
SYNC
NOTE
TEMPO
*a.
Effect list
■Basic parameters
No. Effect name
14 REVERB FLANGE
87 REV+FLANGE
■Fine parameters
No. Effect name
14 REVERB FLANGE
87
REV+FLANGE
70
SPX2000—Owner's Manual
Range
Balance between the original sound and effect sound. At a setting of 0% only the original sound
0—100%
will be output; at a setting of 100% only the effect sound will be output.
Output level after the original sound and effect sound have been mixed.
0—100%
Decrease this value if you want to lower the output. At a setting of 0% there will be no output.
A filter that cuts the low-frequency portion of the effect. Frequency components lower than the
frequency specified here will be cut. With a setting of Thru this filter will do nothing. This filter
does not affect the original sound.
A filter that cuts the high-frequency portion of the effect. Frequency components above the fre-
quency specified here will be cut. With a setting of Thru this filter will do nothing. This filter does
not affect the original sound.
(Reverb + Flanger only) Balance between the reverb and flanger. A setting of 0% outputs only the
0—100%
reverb; a setting of 100% outputs only the flanger.
(Reverb → Flanger only) Amount of flanger. Raising this value will strengthen the flanger effect. At
0—100%
a setting of 0% only reverb will be heard.
Switches tempo synchronization on/off. If this is ON, the speed of modulation will synchronize to
the tempo synchronization source specified by "TEMPO SOURCE" (page 23). The NOTE value
ON, OFF
will be set to the synchronized tempo value.
This parameter is used for tempo synchronization. If SYNC is ON, the FREQ. value will be set
*a
according to this value and TEMPO. If SYNC is OFF, this value is ignored.
This parameter is used for tempo synchronization. If SYNC is ON, the FREQ. value will be set
25—300
according to this value and NOTE. If SYNC is OFF, this value is ignored.
FREQ. DEPTH MOD.DLY
1.10 Hz 80% 1.2 ms
0.25 Hz 88% 0.3 ms
MIX BAL. OUT LVL HPF
76% 100% Thru
100% 100% Thru
Explanation
FB.GAIN WAVE REV TIME
+10% Sine 2.4 s
–84% Tri 1.9 s
LPF REV/FLG REV.BAL
4.25 kHz 60%
Thru 67%
HI.RATIO INI.DLY DIFF.
0.4 0.1 ms 5
0.7 2.4 ms 10
SYNC NOTE TEMPO
OFF —
OFF —
DENSITY
95%
100%