Parts And Their Functions; Front Panel - Yamaha SPX2000 Owner's Manual

Parts and their functions

Front panel

2 3 57
1 4 68
1 [INPUT L R] control
This concentric pair of knobs adjusts the level of the
analog input signal. The inner knob controls the L
channel, and the outer knob controls the R channel.
2 Level meters
These indicate the signal level pre-effect or post-effect
(page 103).
3 [INPUT MODE] button/indicator
This button selects monaural input or stereo input.
The indicator will light to indicate the currently
selected input mode.
4 [METER] button/indicator
This button selects either pre-effect or post-effect as
the signal whose level will be shown in the level meter
( 2 ). The indicator will light to indicate the currently
selected signal.
5 [INPUT SOURCE] indicator
This indicates the currently selected input source. Use
"INPUT SOURCE" (page 19) to select the input
source.
6 [CLOCK] indicator
This indicates the currently selected word clock source.
Use "CLOCK SOURCE" (page 18) to select the word
clock source.
7 [MIDI] indicator
This will light when the SPX2000 receives MIDI data.
8 [kHz] indicator
This indicates the currently-operating word clock fre-
quency.
9 0 B C
A
9 Display
0 Effect number indicator
A [BANK] button/indicator
B [STORE] button
C [ ▲ ]/[ ▼ ] buttons
D [RECALL] button
E [UNDO] button/LED
F [BACK] button
G [ ▲ INC]/[ ▼ DEC] buttons
E F G I J M
D H L K
This displays information about the currently-recalled
effect or the selected utility function.
This indicates the effect number of the currently
selected effect. If the selected effect is different than the
recalled effect, the number will blink. When you store
or recall an effect, the blinking number will change to
steadily lit.
This button selects the effect bank. The indicator for
the selected bank will light. For details on banks, refer
to "Three banks" (page 12).
This button stores the selected effect.
These buttons select an effect.
This button recalls the selected effect.
Use this button when you want to undo the preceding
store/recall/erase operation (page 16). The LED will
light if the [UNDO] button is available.
This button selects the preceding parameter.
Use these buttons to edit parameter values.
SPX2000—Owner's Manual
N O P
7