Yamaha SPX2000 Owner's Manual page 48

■Fine parameters
Parameter name
MIX BAL.
OUT LVL
LSH G –12.0—+12.0 dB
LSH F 21.2 Hz—8.00 kHz
EQ G –12.0—+12.0 dB
EQ F 100 Hz—8.00 kHz
EQ Q
HSH G –12.0—+12.0 dB
HSH F 50.0 Hz—16.0 kHz
SYNC
NOTE
TEMPO
*a.
Effect list
The following tables show the default parameter values for the effect belonging to the Flanger type (PRESET bank).
■Basic parameters
No.
Effect name
69
UP DOWN FLANGE
■Fine parameters
No. Effect name
69 UP DOWN FLANGE
48
SPX2000—Owner's Manual
Range
Balance between the original sound and effect sound. At a setting of 0% only the original sound
0—100%
will be output; at a setting of 100% only the effect sound will be output.
Output level after the original sound and effect sound have been mixed.
0—100%
Decrease this value if you want to lower the output. At a setting of 0% there will be no output.
Gain of the low shelving filter. This adjusts the volume of the low-frequency region. Positive (+)
settings will boost the low-frequency region, and negative (–) settings will attenuate it.
Frequency of the low shelving filter. The LSH G gain applies to the frequency region below this set-
ting.
Gain of the equalizer (peaking type). This adjusts the gain of the frequency region specified by EQ
F. Positive (+) settings will boost the region, and negative (–) settings will attenuate it.
Frequency of the equalizer (peaking type). The EQ G gain setting will affect the region around this
frequency.
Q (sharpness) of the equalizer (peaking type). This indicates the sharpness of the equalizer fre-
10.0—0.10
quency response curve. Higher values will produce a sharper curve.
Gain of the high shelving filter. This adjusts the volume of the high-frequency region. Positive (+)
settings will boost the high-frequency region, and negative (–) settings will attenuate it.
Frequency of the high shelving filter. The HSH G gain applies to the frequency region above this
setting.
Switches tempo synchronization on/off. If this is ON, the speed of modulation will synchronize to
the tempo synchronization source specified by "TEMPO SOURCE" (page 23). The NOTE value
ON, OFF
will be set to the synchronized tempo value.
This parameter is used for tempo synchronization. If SYNC is ON, the FREQ. value will be set
*a
according to this value and the TEMPO value. This value is ignored if SYNC is OFF.
This parameter is used for tempo synchronization. If SYNC is ON, the FREQ. value will be set
25—300
according to this value and NOTE. This value is ignored if SYNC is OFF.
FREQ. DEPTH
1.00 Hz 75%
MIX BAL. OUT LVL
100% 100%
SYNC NOTE
OFF
MOD. FG.
WAVE
DLY GAIN
0.9 ms +60% Sine
LSH G LSH F EQ G
–0.5 dB 140 Hz +12.0 dB
TEMPO
—
Explanation
EQ F EQ Q
4.50 kHz 3.5
HSH G HSH F
0.0 dB 8.00 kHz