Yamaha SPX2000 Owner's Manual page 42

■Fine parameters
Parameter name
MIX BAL.
OUT LVL
HPF Thru, 21.2 Hz—8.00 kHz
LPF 50.0 Hz—16.0 kHz, Thru
SYNC
DLY.NOTE
MOD.NOTE
TEMPO
*a.
*b.
Effect list
The following tables show the default parameter values for the effects belonging to the Modulation Delay type (PRESET
bank).
■Basic parameters
No.
Effect name
66
STEREO PHASING
68
SILKY SWEEP
■Fine parameters
No. Effect name
66 STEREO PHASING
68 SILKY SWEEP
42
SPX2000—Owner's Manual
Range
Balance between the original sound and effect sound. At a setting of 0% only the original sound
0—100%
will be output; at a setting of 100% only the effect sound will be output.
Output level after the original sound and effect sound have been mixed. Decrease this value if you
0—100%
want to lower the output. At a setting of 0% there will be no output.
A filter that cuts the low-frequency portion of the effect. Frequency components lower than the
frequency specified here will be cut. With a setting of Thru this filter will do nothing. This filter
does not affect the original sound.
A filter that cuts the high-frequency portion of the effect. Frequency components above the fre-
quency specified here will be cut. With a setting of Thru this filter will do nothing. This filter does
not affect the original sound.
Switches tempo synchronization on/off. If this is ON, the delay will synchronize to the tempo syn-
chronization source specified by "TEMPO SOURCE" (page 23). The DLY.NOTE and the
ON, OFF
MOD.NOTE value will be set to the synchronized tempo value.
This parameter is used for tempo synchronization. If SYNC is ON, the DELAY value will be set
*a
according to this value and TEMPO. If SYNC is OFF, this value is ignored.
This parameter is used for tempo synchronization. If SYNC is ON, the FREQ. value will be set
*b
according to this value and TEMPO. If SYNC is OFF, this value is ignored.
This parameter is used for tempo synchronization. If SYNC is ON, the DELAY value will be set
according to the DLY.NOTE and TEMPO values, and the FREQ. value will be set according to the
25—300
MOD.NOTE and TEMPO values. If SYNC is OFF, this value is ignored.
DELAY FB.GAIN HI.RATIO
2.0 ms +38%
0.2 ms –40%
MIX BAL. OUT LVL
100% 100% 45.0 Hz
100% 100% 125 Hz
Explanation
FREQ. DEPTH
0.9 0.90 Hz 46%
1.0 0.30 Hz 80%
HPF LPF SYNC
9.00 kHz OFF
Thru OFF
WAVE
Sine
Sine
DLY.NOTE MOD.NOTE TEMPO
—
—