Ring Modulation (Preset Bank) - Yamaha SPX2000 Owner's Manual

Effect list
The following tables show the default parameter values for the effect belonging to the Modulation Filter type (PRESET
bank).
■Basic parameters
No. Effect name
75 MOD FILTER
■Fine parameters
No.
Effect name
75 MOD FILTER

Ring Modulation (PRESET bank)

This effect adds a metallic bell-like resonance.
Each aspect of the sound is controlled by the following effect parameters.
SOURCE, OSC FRQ, FM FREQ., FM DEPTH
Modulation signal:
SYNC, NOTE FM, TEMPO
Tempo synchronization:
OUT LVL, MIX BAL.
Output level:
Parameter details
■Basic parameters
Parameter name Range
SOURCE OSC, SELF
OSC FRQ 0.0—5000.0 Hz
FM FREQ. 0.05—40.00 Hz
FM DEPTH 0—100%
■Fine parameters
Parameter name Range
MIX BAL. 0—100%
OUT LVL 0—100%
SYNC ON, OFF
NOTE FM
TEMPO 25—300
*a.
Effect list
The following tables show the default parameter values for the effect belonging to the Ring Modulation type (PRESET bank).
■Basic parameters
No. Effect name
74 RING MODULATION
■Fine parameters
No.
Effect name
74 RING MODULATION
FREQ. DEPTH PHASE
0.25 Hz 60% 180.00 dg
MIX BAL. OUT LVL SYNC
100% 100% OFF
Source of the modulating signal. If you select OSC, an oscillator signal will modulate the ampli-
tude. If you set this to SELF, the input signal will modulate itself.
Oscillator frequency. This indicates the speed of modulation. Increasing this value will make the
volume change over a shorter cycle. This value is valid if SOURCE is set to OSC.
Speed of modulation applied to the oscillator signal. This ring modulator effect lets you use the FM
FREQ. parameter to apply additional modulation to the oscillator signal.
Depth of modulation applied to the oscillator signal. Increasing this value will increase the modu-
lation that is applied to the oscillator signal.
Balance between the original sound and effect sound. At a setting of 0% only the original sound
will be output; at a setting of 100% only the effect sound will be output.
Output level after the original sound and effect sound have been mixed.
Decrease this value if you want to lower the output. At a setting of 0% there will be no output.
Switches tempo synchronization on/off. If this is ON, the speed of modulation will synchronize to
the tempo synchronization source specified by "TEMPO SOURCE" (page 23). The NOTE FM
value will be set to the synchronized tempo value.
This parameter is used for tempo synchronization. If SYNC is ON, the FM FREQ. value will be set
*a
according to this value and the TEMPO value. This value is ignored if SYNC is OFF.
This parameter is used for tempo synchronization. If SYNC is ON, the FM FREQ. value will be set
according to this value and NOTE FM. This value is ignored if SYNC is OFF.
SOURCE OSC FRQ FM FREQ.
OSC 880.0 Hz 1.30 Hz
MIX BAL. OUT LVL SYNC
100% 100% OFF
TYPE OFFSET RESO.
BPF 8 5
NOTE TEMPO
—
Explanation
Explanation
FM DEPTH
45%
NOTE FM TEMPO
—
SPX2000—Owner's Manual
57