Confirmation Messages - Yamaha S Rev1 Owner's Manual

88
Appendix
Confirmation Messages
Message
CURRENT IS EDITED.
RECALL PROGRAM OK?
CURRENT IS EDITED,
LOAD LIBRARY OK?
SAME LIBRARY EXISTS!
OVERWRITE OK?
DELETE LIBRARY OK?
CURRENT IS EDITED.
LOAD PROJECT OK?
SAME PROJECT EXISTS!
OVERWRITE OK?
DELETE PROJECT OK?
LOAD DATA OK?
CHANGE REV MODE OK?
SREV1—Owner's Manual
Condition
Appears when you recall a program from
the Quick memory page, but the current
program contains unsaved changes.
Appears when you recall a program from
the Library page, but the current pro-
gram contains unsaved changes.
Appears when you save the current pro-
gram on the Library page, but a pro-
gram with the same title already exists.
Appears when you edit the title of the
selected program on the Library page,
but a program with the same title
already exists.
Appears when you delete the selected
program on the Library page.
Appears when you recall a project from
the Project page, but the current pro-
gram contains unsaved changes.
Appears when you save a project on the
Project page, but a program with the
same title already exists.
Appears when you edit the title of the
selected project on the Project page, but
a program with the same title already
exists.
Appears when you delete the selected
project on the Project page.
Appears when you load the selected
impulse-response data from the Data
Load page.
Appears when you select a different
Reverb mode on the Setup page.
Solution
To discard the current program's
unsaved changes and recall the pro-
gram, press OK. To cancel the operation,
press CANCEL.
To discard the current program's
unsaved changes and load the program,
press OK. To cancel the operation, press
CANCEL.
To save and overwrite the existing pro-
gram, press OK. To cancel the operation,
press CANCEL.
To overwrite the existing program, press
OK. To cancel the operation, press CAN-
CEL.
Press OK to delete the selected program.
To cancel the operation, press CANCEL.
To discard the current program's
unsaved changes and load the project,
press OK. To cancel the operation, press
CANCEL.
To save and overwrite the existing pro-
gram, press OK. To cancel the operation,
press CANCEL.
To save and overwrite the existing pro-
gram, press OK. To cancel the operation,
press CANCEL.
Press OK to delete the selected program.
To cancel the operation, press CANCEL.
Press OK to load the selected
impulse-response data. To cancel the
operation, press CANCEL.
Press OK to switch to the Reverb mode.
To cancel the operation, press CANCEL.