Setting Input & Output Levels - Yamaha S Rev1 Owner's Manual

36
Chapter 4—Basic Operation
Setting Input & Output Levels
Input and output signal levels can be set on two different pages: Main 2 page or Meter
I/O page. On the Main 2 page, levels are adjusted for all channels simultaneously as a
group, while on the Meter I/O page, they can be adjusted for each channel individually.
This section explains how to adjust input and output levels on the Meter I/O page. See
page 54 for information on the Main 2 page.
Use the [UTILITY] button to locate the Meter I/O page.
1
2-ch mode
2-ch x2 mode
Use the cursor buttons to select the INPUT LEVEL and OUTPUT LEVEL param-
2
eters for each channel.
Use the faders to set the levels.
3
The DATA wheel or [–1/DEC] and [+1/INC] buttons can also be used to set levels in
0.1 dB steps.
The input and output levels can be set from – , –72.0 dB to +6.0 dB in steps of 0.1 dB.
SREV1—Owner's Manual
4-ch mode