Selecting Reverb Modes - Yamaha S Rev1 Owner's Manual

34
Chapter 4—Basic Operation

Selecting Reverb Modes

This section explains how to select the 2-channel, 4-channel, and 2-channel x2 Reverb
modes. See page 6 for more information about each mode.
Use the [UTILITY] button to locate the Setup page shown below.
1
Use the cursor buttons to select the 2CH, 4CH, or 2CHX2 button in the REV
2
MODE section of the page.
Press the [ENTER] button.
3
A confirmation message appears.
Select YES to continue, or select NO to cancel the operation.
4
Press the [ENTER] button.
5
While the SREV1 switches to the selected Reverb mode, the RC-SREV1 displays the
message "SETTING REV MODE..." and the SREV1 INPUT and OUTPUT signal indi-
cators light up in sequence.
Note: Do not insert or eject a PC Card or CD-ROM while the SREV1 is changing Reverb
modes.
Once the mode has been set, the mode title appears in the Reverb mode section of the
display, the Program page is selected, and the cursor appears at the same position it does
when the power is turned on.
The SREV1 switches to the selected mode, the mode title appears in the Reverb mode
section of the display, and the Program page is selected.
The SREV1 stores all program parameters when the mode is changed, so when you
return to a mode, the previous settings are restored.
SREV1—Owner's Manual
Reverb mode