Health O Meter 522KL Manual page 7

ASSEMBLY INSTRUCTIONS (CONTINUED)
1. Carefully remove the contents of the
carton and place each part on a flat,
level, and dry surface. Remove the
4 column mounting screws and
washers from the bottom of column
and set aside for assembly step 5.
2. Remove the black adapter bracket
from scale platform. Place the
bracket on the bottom of the column
with the adapter jack arrow sticker
pointing towards the front of the
column.
3. Place the scale platform on its side
and place the column on its side,
perpendicular to the platform. The
front of the display head on the
column should be facing forward
and above the scale platform.
4. Locate the load cell connector cable
inside the column and pull gently
until the plug reaches the bottom of
the column. Carefully pull the cable
connector from the bottom of the
column and plug into the RJ jack on
the scale platform. Caution: Once
connected, keep a firm grip on the
column to ensure the load cell
connector cable is not pulled out
from the RJ jack. This cable
connects the load cells to the
display head and must be entirely
plugged in for the scale to
function properly.
5. Position and secure the column to
the scale platform. Locate the 4
column mounting screws previously
removed in step 1. Insert the 4
screws through the bottom of the
scale platform screw holes and into
the column. Ensure that washers
are located between the screw
heads and the scale platform screw
holes. Using a Phillips head
screwdriver, tighten the screws to
secure the column to the base of the
platform.
P/N UM522KL 522KG 524KL 524KG Rev20230223
Screws and washers
RJ Jack
7
Back to Home Page