Health O Meter 522KL Manual page 10

SET UP INSTRUCTIONS
To enter the Options mode, push and hold the UNIT button while pressing and releasing
the button.
Auto Off Function
When powering the scale via the AC adapter, the display can be set to power off after a
period of inactivity. The Auto Off default setting is "disabled". Follow this procedure to
enable or disable the Auto Off function. Note: When powering the scale via batteries, the
Auto Off function is automatically enabled.
Enable / Disable Auto Off
1. While the scale is turned off, press and hold the UNIT button then press and release the
button. Hold the UNIT button until "AOF=d" or "AOF=E" appears on the display, then
release. Press the UNIT button again to change the setting.
AOF=d Disables the Auto Off function
AOF=E Enables the Auto Off function
2. Press HOLD/RELEASE to save your selection and exit the Options mode.
3. The scale will restart. The display will show "UEr", followed by a version number, and
then dashes. When the display shows "0.0" the scale is ready to use.
Setting Auto Off Time
When powering the scale via batteries or if Auto Off is Enabled for the AC adapter, the period
of inactivity before the scale powers off can be set to a specific amount of time. The default
setting for Auto Off time is 2 minutes. Follow this procedure to set the number of minutes of
inactivity before power off.
1. While the scale is turned off, press and hold the UNIT button then press and release the
button. Hold the UNIT button until "AOF=d" or "AOF=E" appears on the display, then
release. Use the ZERO/TARE to advance or the
screen until "AFt" appears. Press the UNIT button to change the Auto Off time.
AFt = 1 Scale will power off after 1 minute of inactivity
AFt = 2 Scale will power off after 2 minutes of inactivity
AFt = 3 Scale will power off after 3 minutes of inactivity
2. Choose the setting you prefer and press HOLD/RELEASE to save your selection and
exit the Options mode.
3. The scale will restart. The display will show "UEr", followed by a version number, and
then dashes. When the display shows "0.0" the scale is ready to use.
Auto Hold
The Auto Hold function allows the scale to continue displaying the weight measurement after
the patient is removed from the weighing tray/seat. The Auto Hold setting can be adjusted to
display the weight for 0, 30, or 60 seconds. The default setting is 30 seconds. Follow this
procedure to adjust the Auto Hold setting.
1. While the scale is turned off, press and hold UNIT button then press and release the
button. Hold the UNIT button until "AOF=d" or "AOF=E" appears on the display, then
release. Use the ZERO/TARE to advance or the ON/OFF button to scroll back the
display screen until "AHd" appears. Press UNIT to change the setting.
AHd = 0 Weight measurement will not be held on the display after the patient is removed
AHd = 1 Weight measurement will hold on the display for 30 seconds
AHd = 2 Weight measurement will hold on the display for 60 seconds
2. Choose the setting you prefer and press HOLD/RELEASE to save your selection and exit
the Options mode.
3. The scale will restart. The display will show "UEr", followed by a version number, and then
dashes. When the display shows "0.0" the scale is ready to use.
P/N UM522KL 522KG 524KL 524KG Rev20230223
button to scroll back the display
10
Back to Home Page