Dometic FreshJet FJX Service Manual page 14

EN Dometic FJX

2. Remove the process pipe using a needle-nose pliers.
3. Place a new process pipe to the roof unit.
The process pipe must have the following properties:
• Material: Copper
• Length: ≥ 130 mm
• Diameter: 6 mm
4. Fix the new process pipe by protection gas brazing.
NOTE Use a nitrogen during gas shielded soldering to prevent oxidation of the pipes.
Performing a high pressure test
WARNING! Explosion hazard
Only use oxygen free nitrogen.
1. Connect the quick connector to the process pipe.
14