Table of Contents
Advertisement
8.3 Loading All Data from a Card
(1) Gently insert the card into the slot.
(2) Press the LOAD switch.
If the card is properly inserted, the LED in the switch
lights and the word CARD appears on the multi-
function display. If the LED does not light, pull out
the card and start again.
If the card contains data, the flower right hand
corner of the display gives the block name. if the
card is unformatted, the message "NEW" appears
on the screen. Press the LOAD switch a second
time, extract the card, and start again with another.
{3)
Use the arrow keys to select the index number in
the upper right hand corner of the display.
(4)
Press the WRITE switch in the registration memory
section to start the load operation.
(5) Wait for the organ to give a short beep, for the
message "OK" to appear on the display, and for the
LED in the LOAD switch to go out, signaling the
successful completion of the operation.
48
8.4 an
a Program Registration
by Itself
.
{1) Repeat steps 1-3 of the preceding procedure.
(2) Press the SELECT
switch
to select a program
registration number (1 ~ 7, P (Panel)).
Note:
There are five number switches on the SR5, seven on
the SR6 and SR/.
(3) Press the WRITE switch in the registration memory
section to start the load operation.
Note:
The select registration is always loaded as programm-
able registration No. 1.
(4) Wait for the organ to give a short beep, for the
message "OK" to appear on the display, and for the
LED in the LOAD switch to go out, signaling the
successful completion of the operation.
Advertisement
Table of Contents
