Table of Contents
Advertisement
i Procedure (INTRO)
(1) Make sure that the rhythm accompaniment is on
standby — that is, that the LED in the RHYTHM
switch
is on. If the LED
is off, intros are not
available.
NV
Fh
{2) Press the INTRO/ENDING switch.
Nee
ad
-H
INTRO/
EASNG
an
Note:
After a one-bar introduction, the rhythm accompani-
ment starts. The LED in the INTRO/ENDING switch
flashes during the introduction and then goes out.
@ Procedure (ENDING)
{1) Start the rhythm accompaniment by striking a key
of the LOWER keyboard. The organ cannot supply
an ending to a pattern that is not active.
(2) Press the INTRO/ENDING switch.
(3) When
you
near
the point where
you
want
the
ending, press the right foot switch.
After the ending, the rhythm accompaniment stops. The
LED in the INTRO/ENDING switch flashes during the
ending and then goes out.
27
4.3 Hand Percussion
The SR Series provides not only prerecorded
rhythm
patterns, but also solo percussion instruments. These are
accessible through two means: the LOWER keyboard and
touch bars located just below that keyboard.
@ Procedure (LOWER keyboard)
(1) Press the HAND PERCUS switch so that the LED
lights and
the
message
VA.O
(VARIATION
0)
appears on the screen.
PEACUS.
Note:
Switching over to hand percussion disables the auto-
matic accompaniment,and most other functions which
use the LOWER keyboard.
(2) Press the keys for the desired percussion instru-
ments.
Notes:
¢ The volume depends on the force of the keystroke.
¢ There are four sets of labels under the keys. The top
row is for the black keys. The other three are for the
white keys and cover the percussion instrument and
two variations (VARI. 1 and VARI. 2).
Press the special white key, labelled VARI. 1, at the
right end of the keyboard to change the instrument
assignmenis for the white keys from the second
row to the third.
Note:
The message VA.1 should appear on the display.
{3
—
Advertisement
Table of Contents
