Pioneer CA-100 Operating Instructions Manual page 3

Two pin-plug cords are included as accessories. These
are to be used to connect the sound processor to your
stereo amplifier. The white plug is for the left channel,
and the red plug is for the right channel.
@ TAPE A TERMINALS
(FOR SINGLE DECK OR
PIONEER'S W DECK)
Use these terminals when connecting a single or
double deck to this unit.
NOTE:
Under no circumstances should a single deck be con-
nected to these terminals and the deck selector switch set
to "TAPE A" since vibrations will result which may cause
trouble in the deck.
@ DECK SELECTOR SWITCH
Set this switch to the position corresponding to the
type of cassette deck being used: set to "TAPE A"
when connecting a double cassette deck and to
"TAPE B" when connecting a single deck.
© TAPE B TERMINALS
(FOR SINGLE DECK)
Two single decks can be used to substitute for a dou-
ble deck. In this case, connect the deck used for
playback only to these terminals and connect the
recording deck to the TAPE A terminals. Recording
and playback are possible with these decks.
Any mention of a "double deck" in these In-
structions is a reference to the double
cassette deck made by PIONEER. It does
not refer to any other double cassette deck
since no other deck can be expected to
function to the same standard.
"Power cord
@ TAPE-CREATING INPUT/OUTPUT
TERMINALS
These terminals are used to connect the stereo
amplifier to the unit.
Connect to the stereo amplifier's TAPE 2 monitor ter-
minals. Use the ADAPTOR/TAPE 2 terminals when
the unit is used in combination with the PIONEER
stereo components.
@ AC OUTLETS (UNSWITCHED TOTAL
100 W MAX)
Power flows continually to these outlets, regardless
of whether the amplifier is switched ON or OFF. Elec-
trical power consumption of the connected equip-
ment should not exceed 100 W.
The equipment should be disconnected by removing
the mains plug from the wall socket when not in
regular use, e.g. when on vacation.
NOTE:
Do not connect appliances with high power consumption
such as heaters, irons, or television sets to the AC
OUTLETS, in order to avoid overheating or fire risk. This
can cause the amplifier to malfuncion.