Before Operation; Batteries Installation; Using An External Power Source - Camouflage EZ2 Elite Manual

4.BEFORE OPERATION

Power supply

4.1.Batteries Installation

Open the camera by unlocking the latch firstly. The battery compartment is the right
part of the camera. Open the protective cover of the battery compartment and insert
4 x 1.5 V LR6/AA batteries into the battery slots. Make sure to insert each battery with
correct polarity (+ and - end against the long spring of each battery slot). To increase
the operating time, you can use 8 x 1.5 V LR6/AA batteries. When using 4 batteries,
they all should be installed in the top 4 slots or in the bottom 4 slots.
Note:
NEVER INSTALL DIFFERENT TYPES OF BATTERIES or NEW AND OLD BATTERIES
in the product at the same time.
Anytime you load or unload batteries, make sure that the camera is OFF. If using
an external power source, do not remove internal batteries.

4.2.Using an External Power Source

Optionally, you can connect an external 6V DC power source to the 'DC In 'jack at the
bottom of the camera. The power connector is a 3.5x1.35 mm coaxial DC power plug with
positive 'tip'(inside pin) polarity. Leave internal batteries in the camera during use.
04