Align The Camera As Follows; Camera Is Ready To Use - Camouflage EZ2 Elite Manual

5.CAMERA OPERATION

5.25.Align the camera as follows:

Fasten the camera to a tree or similar object at a height of 0.8- 1.5 meters and align
the camera in the desired direction Then move slowly from one side of the target area
to the other side. While doing this, monitor the motion display.
Under TEST made, indicator flashing in Red means infrared is detected by motion
sensor.
Under ON mode, indicator flashes in Blue when camera counts down 15 seconds
before LCD turns off︒
To ensure that the camera does not make unwanted recordings of irrelevant
movements, it should not be set up in a sunny location or close to branches that can
move in the wind.

6.CAMERA IS READY TO USE

CAMERA IS READY TO USE-—Switch to ON
AFTER CHANGING TO DESIRED SETTING and SIMPLY SLIDING SWITCHES TO ON
POSITION, the camera is active standby mode and will record media according to the
switch settings. Firstly, the motion indicator LED will blink blue for about 15 seconds.
12