Automatic Preset Tuning - Yamaha RX-V10MKII Owner's Manual

Automatic preset tuning

You can make use of an automatic preset tuning function for FM stations. With this function, this unit performs automatic tuning and
stores FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual
preset tuning method on page 28.
<
* Europe and U.K. models only
Only RDS stations can be stored by this function.
To store stations
1
FM/AM
2
MEMORY
MAN'L/AUTO FM
MEMO
AUTO
The automatic preset tuning begins from A1. Received
stations are programmed to A1, A2 ... A8 sequentially.
* If more than 8 stations are received, they are also
programmed to the preset station numbers on other
groups (B, C, D and E) in that order.
>
NATURAL SOUND AV RECEIVER RX–V10MK
STANDBY/ON
PHONES SPEAKERS RDS MODE / FREQ EON A / B /
ON OFF
PTY SEEK FM
MODE START
1 2
FM
Press and hold for
about 3 seconds.
PRESET
Flashes.
INPUT VOLUME
DVD-LD/VCR/V-AUX/TAPE•MD/CD/TUNER/PHONO
6CH/2CH
0 I0
PTY SELECTOR
PRESET STATIONS
TUNING
C / D / E KEY MODE BASS TREBLE BALANCE
0 0
EDIT
TUNING CENTER
/ AM MODE MEMORY MODE PROGRAM
– + – + L R
AUTO / MAN'L MONO MAN'L / AUTO FM
CINEMA DSP
When the automatic preset tuning is finished
The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section "To recall a preset
station" on page 28.
To recall a preset station
Simply follow the procedure of the section "To recall a preset
station" on page 28.
<
* Europe and U.K. models only
A recalled station is shown by the frequency or station name
on the display.
Notes
•
You can replace a preset station by another FM or AM
station manually by simply following the procedure of the
section "To store stations" on page 28.
<
General model only
•
If the number of received stations is not enough to be stored
up to E8, the search will be finished automatically after
searching all frequencies.
•
With this function, only FM stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section "To store stations" on page 28.
<
Europe and U.K. models only
•
The automatic preset tuning search is performed through all
RDS network frequencies until stations are stored up to E8.
If the number of received stations is not enough to be stored
up to E8, the search will be finished automatically after
searching all frequencies.
•
With this function, only RDS stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section "To store stations" on page 28.
* There may be a case that this function cannot receive a
station which could be received by the automatic tuning
method. This is because this function receives a large
volume of PI (Program Identification) data along with the
station.
>
>
>
29