Yamaha RX-V10MKII Owner's Manual page 22

NATURAL SOUND AV RECEIVER RX–V10MK
STANDBY/ON
PHONES
6
Select the center channel output mode suitable for your
speaker configuration.
(Refer to "Speaker configuration" on page 8.)
CENTER
MODE
For the feature of each mode, refer to the "Note" shown
below.
7
TEST
Note
In step 6, when you select a center channel output mode, note
the following.
For 5-speaker configuration
NORMAL: Select this mode when you use a center speaker
that is smaller than the main speakers. In this
mode, the bass tone will be output from the main
speakers.
WIDE: Select this mode when you use the center speaker
approximately same sized as the main speakers.
For 4-speaker configuration
PHANTOM: Select this mode when you do not use the center
speaker. The center sound will be output from the
left and right main speakers.
22
INPUT
DVD-LD/VCR/V-AUX/TAPE•MD/CD/TUNER/PHONO
6CH/2CH
PTY SELECTOR
PRESET STATIONS
TUNING
SPEAKERS RDS MODE / FREQ EON A / B / C / D / E KEY MODE BASS
0
EDIT
ON OFF
TUNING CENTER
PTY SEEK FM / AM MODE MEMORY MODE PROGRAM
– +
MODE START AUTO / MAN'L MONO MAN'L / AUTO FM
6
NORMAL
WIDE
PHANTOM
TEST
Flashes continuously
8
VOLUME
0 I0
TREBLE BALANCE
0
– +
L R
CINEMA DSP
8
Turn up the volume.
You will hear a test tone (like pink noise) from the left main
speaker, then the center speaker, then the right main
speaker, and then the rear speakers, for about two seconds
each. The display changes as shown below.
* The test tone from the left rear speaker and the right
rear speaker will be heard at the same time.
* The state of the test tone output is also shown on the
monitor screen by an image of the audio listening room.
This is convenient for adjusting each speaker level.
DELAY/CENTER
– +
LEVEL /REAR/SWFR TEST EFFECT
ON/OFF
PROGRAM PROLOGIC ENHANCED
DVD/LD
V-AUX VCR 2CH/6CH
PLAY
DIR A DIR B REC/PAUSE
TAPE
A/B
– +
A/B/C/D/E TUNER
PRESET
PLAY
DISC CD
PHONO
POWER /I VOLUME
SLEEP
VOLUME
or
0 I0
Main (L) Center
Rear Main (R)
(L and R)
7
8
VOLUME
CONTINUED