Recording A Source To Tape (Or Md) - Yamaha RX-V10MKII Owner's Manual

To listen to a decoded source using Dolby
Digital or DTS by reproducing the signals input
to the DVD/LD 6CH DISCRT INPUT terminals of
this unit.
In step 4, turn the INPUT selector on the front panel or press
the DVD/LD (2CH/6CH) key on the remote controller
repeatedly until "DVD 6ch" appears on the display.
INPUT
DVD-LD/VCR/V-AUX/TAPE MD/CD/TUNER/PHONO
6CH / 2CH
or
PTY SELECTOR
To cancel listening to a decoded source using Dolby
Digital or DTS
Select another input source.
Note for reproducing discrete signals with Dolby Digital or
DTS decoded:
1. Your speaker system must include a center speaker.
2. Your speaker system may include a subwoofer.
* Connect a subwoofer which has a built-in amplifier to the
SUBWOOFER OUT terminal of this unit.
* You can do without using a subwoofer. If you do so, you
must set the Dolby Digital Decoder etc. so that signals at
the subwoofer channel are distributed to the right and left
MAIN output terminals.
For details, refer to the owner's manual for the Dolby
Digital Decoder etc.
Notes
When you switch to the "6ch" mode, the built-in Digital
Sound Field processor will not work and adjustment of delay
time cannot be made.
Switching this unit to the "6ch" mode will input no signal to
this unit if there is no connection to the DVD/LD 6CH
DISCRT INPUT terminals of this unit.
DVD/LD
2CH/6CH
Press once or twice.

Recording a source to tape (or MD)

NATURAL SOUND AV RECEIVER RX–V10MK
STANDBY/ON
PHONES SPEAKERS RDS MODE / FREQ EON A / B / C / D / E
ON OFF
TUNING
PTY SEEK FM / AM MODE
MODE START AUTO
1
Select the source to be recorded.
DVD-LD/VCR/V-AUX/TAPE MD/CD/TUNER/PHONO
6CH / 2CH
2
Play the source and then turn the VOLUME control up
to confirm the input source. (Refer to the page 27 for
details on tuning.)
0
3
Begin recording to the tape deck (or MD recorder etc.)
or VCR connected to this unit.
Notes
The settings of DSP and the VOLUME, BASS, TREBLE
and BALANCE controls have no effect on the material
being recorded.
In step 1, do not make an input source selection so that
"DVD 6ch" appears in the display. Signals input to this
unit's DVD/LD 6CH DISCRT INPUT terminals cannot be
recorded by a tape deck (or MD recorder) or VCR.
1 2
INPUT VOLUME
DVD-LD/VCR/V-AUX/TAPE•MD/CD/TUNER/PHONO
6CH/2CH
PTY SELECTOR 0 I0
PRESET STATIONS
TUNING
KEY MODE BASS TREBLE BALANCE
0 0
EDIT
CENTER
MEMORY MODE PROGRAM
– + – +
L R
/ MAN'L MONO MAN'L / AUTO FM
CINEMA DSP
INPUT
PTY SELECTOR
VOLUME
I0
25