Connecting Antennas - Yamaha RX-V10MKII Owner's Manual

Connecting antennas

Each antenna should be connected to the designated terminal(s) correctly, as shown in the following figure.
Both AM and FM indoor antennas are included with this unit. In general, these antennas will provide sufficient signal strength.
Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception
quality only with the indoor antennas, the use of an outdoor antenna may result in improvement.
Outdoor FM antenna
Connecting the AM loop antenna
1. Press the tab and unlock the terminal hole.
2. Connect the AM loop antenna lead wires to the AM ANT
and GND terminals.
3. Return the tab back to the original position to lock the lead
wires. Lightly pull on the lead wires to confirm a good
connection.
1
3
14
75-ohm/300-ohm
antenna adapter
75-ohm coaxial cable
75-ohm/300-ohm
antenna adapter
300-ohm flat ribbon cable
2
Indoor FM
antenna
(included)
3
IN
TAPE
FM
/MD
ANT
75
4
UNBAL .
OUT
GND GND
V-AUX
AM
ANT
IN
VCR
OUT
DVD
/LD
PHONO
AUDIO SIGNAL
Ground
4. Attach the loop antenna to the antenna stand.
Antenna stand
5. Orient the AM loop antenna so that the best reception is
obtained.
Notes
The AM loop antenna should be placed apart from the
main unit. The antenna may be hung on a wall.
The AM loop antenna should be kept connected, even if
an outdoor AM antenna is connected to this unit.
Outdoor AM antenna
AM loop
antenna
(included)
(Europe model)
Loop antenna