Playing And Recording A Source; Playing A Source - Yamaha RX-V10MKII Owner's Manual

From pages 24 to 39, this manual describes how to operate this unit mainly by using the front panel control parts.
To operate this unit on the remote controller, use the corresponding keys on the remote controller.

PLAYING AND RECORDING A SOURCE

Playing a source

1
Set to the "0" position.
2
Turn on the power.
3
Make sure that the SPEAKERS switch is set to the ON
position. If it is not so, press and set the SPEAKERS
switch inward (ON).
4
Select the desired input source by turning the INPUT
selector so that the name of the source appears on the
display.
(For video sources, turn on the TV monitor.)
DVD-LD/VCR/V-AUX/TAPE MD/CD/TUNER/PHONO
6CH / 2CH
24
2
NATURAL SOUND AV RECEIVER RX–V10MK
STANDBY/ON
PHONES SPEAKERS
ON OFF
3
VOLUME
0 I0
STANDBY/ON
SPEAKERS
ON OFF
INPUT
PTY SELECTOR
4
INPUT
DVD-LD/VCR/V-AUX/TAPE•MD/CD/TUNER/PHONO
6CH/2CH
PTY SELECTOR
PRESET STATIONS
RDS MODE / FREQ EON A / B / C / D / E TUNING KEY MODE BASS TREBLE
0
EDIT
TUNING CENTER
PTY SEEK FM / AM MODE MEMORY MODE PROGRAM
– + –
MODE START AUTO / MAN'L MONO MAN'L / AUTO FM
7
5
Play the source. (Refer to page 28 for details on
tuning.)
6
7
Adjust the BASS, TREBLE and BALANCE controls
(refer to page 26), and use the digital sound field
processor. (Refer to page 36.)
Note
The INPUT selector selects the source connected to the input
terminals on the rear panel whose name is identical with the
name shown on the display.
When you finish using this unit
Press the STANDBY/ON switch on the front panel again or
the POWER
standby mode.
1, 6
VOLUME
0 I0
BALANCE
0
+
L R
CINEMA DSP
VOLUME
0
Adjust the output level.
/I key on the remote controller to enter the
I0