Kenwood TS-850S Instruction Manual page 21

the desired
transmit.
IF _ filter
MODE key
Press the LSB/USB key to
alternate between LSB and
USB.
RIT/XIT switch/control
SQL(Squelch) control
NOTCH switch/control
NB switch/control
NB 1:For pulse type noise,
such as generated by au-
tomotive ignition systems.
RF gain control NB 2: Noise blanker 2 is used
This control should be all the for long duration pulse
way to the right. noise, like the ''wood-
pecker''.
TONE control
Turn the control to increase
or decrease the tone.
SLOPE TUNE control
FINE key
Makes one turn of the tuning
knob equal 1
step) to facilitate tuning. Channel Operation.
M.CH/VFO CH control
This control is also used to
select the desired memory
kHz (1 Hz| | channel during
This control is used to
Memory
TUNE key change the frequency in 10
Reduces output power for| |kHz steps during VFO
linear amplifier adjustment. operations.
(TRANSMISSION)
Connect a microphone to the MIC jack.
Turn on the DC power supply and then turn the transceiver's power switch ON.
A frequency is shown in the display.
ga Select USB or LSB with the MODE key.
The automatic switchover point on the transceiver is 9.5 MHz.
Enter the desired frequency.
Before transmitting check the frequency for activity so that you do not interrupt another QSO.
Press the METER key until the ALC meter lights.
Press the microphone PTT switch, or set the REC/SEND switch to SEND.
| 8 | Speak into the microphone and adjust the MIC gain control so that the meter deflection does not exceed the ALC
zone on voice peaks.
Note (a
Speak into the microphone, holding the microphone 'soonoGoobocondenadonoocn40000
about 5 cm away from your mouth. Close talking or eS
talking too loudly may reduce transmission clarity or bats k= Alc sone: 7S
spread the side bands too much.