Kenwood TS-850S Instruction Manual page 28

ey to the
If it is set
maximum
ion for
5 kHz.
METER key
Used to select the desired
meter function in transmit.
MODE key
Press the FM/AM key to
alternate between FM and
AM.
SQL(Squelch) control
RF gain control
way to the right.
This control should be all the
TONE control
Turn the control to increase
or decrease the tone.
M.CH/VFO CH control
This control is used to
change the frequency in 10
kHz steps during VFO
operations.
This control is also used to
select the desired memory
channel during Memory
Channel Operation.
(TRANSMISSION)
Connect a microphone to the MIC jack.
Turn on the DC power supply and then turn the transceiver's power switch ON.
BH 8
~ |
A frequency is shown in the display.
Select FM with the MODE key.
Enter the desired frequency within the 28 MHz amateur radio band.
Before transmitting check the frequency for activity so that you do not interrupt another QSO.
Press the METER key until the ALC meter lights.
Press the microphone PTT switch, or set the REC/SEND switch to SEND.
voice peaks.
Note
Speak into the microphone, holding the microphone
about 5 cm away from your mouth. Close talking or
talking too loudly may reduce transmission clarity or
spread the side bands too much.
ay a A a aa a |
S43 st 8 20 ao ome,
ooog0go00D0000000000000000000
fe ee aL ae
a aes ee
ae ————
$48 SooagacdesnsaogosacseccoooEeee
cone TORS 3S
ke ALC Zone} ne
25