Disabling Automatic Selection Of Voice Sets (Effects, Etc.); Displays - Yamaha PSR-S710 Reference Manual

2 DSP
[1 ▲▼]–
[4 ▲▼]
[5 ▲▼]–
[8 ▲▼]
[5 ▲▼]
1
[6 ▲▼]
–[8 ▲▼]
3 EQ
Determines the Frequency and Gain of the Low and High EQ bands. For information about EQ, refer to
page 78.
■ HARMONY Page
Same as in the [FUNCTION] → [H] HARMONY/ECHO display. See "Selecting the Harmony/Echo
type" on

Disabling Automatic Selection of Voice Sets (Effects, etc.)

Each Voice is linked to its default VOICE SET parameter settings. Usually these settings are automatically
called up when a Voice is selected. However, you can also disable this feature by the operation in the relevant
display as explained below.
For example, if you want to change the Voice yet keep the same Harmony effect, set the HARMONY/ECHO
parameter to OFF (in the display explained below).
1
Call up the operation display.
[FUNCTION] → [E] REGIST SEQUENCE/FREEZE/VOICE SET → TAB [E][F] VOICE SET
2
Use the [A]/[B] buttons to select a keyboard part.
2
3
Use the [4 ▲▼]–[7 ▲▼] buttons to enable/disable automatic calling up of the settings
(ON or OFF) independently for each parameter group.
14
PSR-S910/S710 Reference Manual
DSP TYPE
VARIATION
ON/OFF
PARAMETER
VALUE
page 6.
Selects the DSP effect category and type. Select a type after selecting a
category.
Two variations are provided for each DSP type. Here, you can edit the
VARIATION on/off status and variation's parameter value setting.
Turns the DSP Variation on or off for the selected Voice. This setting
can also be made from the VOICE CONTROL [DSP VARI.] button on
the panel. (This button is effective only when the [DSP] button is on.)
Displays the variation parameter. (This differs depending on the effect
type and cannot be changed.)
Adjusts the value of the DSP variation parameter.
3