Repositioning The User Interface For The Application; Installing The Duct Collars - Aprilaire E080 Installation & Owner's Manual

REPOSITIONING THE USER INTERFACE FOR THE APPLICATION

Locate the onboard user interface on the top of the
dehumidifier or at the front of the dehumidifier if the user
interface cannot be seen/accessed in the top orientation It
may also be rotated 180 degrees in either orientation (see
FIGURE 10)
FIGURE 9: USER INTERFACE LOCATION
B
A
A. USER INTERFACE DOOR
B. USER INTERFACE
C. FILTER ACCESS DOOR
FIGURE 10: USER INTERFACE ROTATED 180 DEGREES
MOVING THE CONTROL
1. Remove the front user interface door
2. Remove the filter access door and filter.
3. Detach the onboard user interface by removing the four (4)
screws around the user interface
NOTE: Use one hand to support the bottom of the onboard
user interface when removing
4. Keep the user interface in the unit and relocate to the front
access hole
5. Secure the user interface with the same four screws used to
attach the user interface to the top of the unit
6. Secure the user interface door to the top of the unit
A
B
C

INSTALLING THE DUCT COLLARS

• Use the screws in the parts bag to attach the duct collars to
the inlet and outlet of the dehumidifier. The outlet collar has a
backflow damper.
• The outlet duct collar may be attached to the top or end of
the unit Move the outlet cover to the location not being used
(see FIGURE 11)
• Make sure there are no bends in the ductwork coming off
the outlet for a minimum of 4" This precaution will ensure
that the ductwork will not interfere with the backflow damper
function
FIGURE 11: FULLY DUCTED INSTALLATIONS
END DISCHARGE
A
C
90-1884
TOP DISCHARGE
A
A. INLET DUCT COLLAR
90-2525
B. OUTLET COVER
C. OUTLET DUCT COLLAR WITH BACK DRAFT DAMPER
B
C
C
B
90-2592
7