Kohler KDI 3404TM Owner's Manual page 29

Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
•
6.1 Engine oil replacement
• Place engine on level surface to ensure accurate
measurement of oil level.
• Before proceeding, perform the operation described in
Par. 6.2 - Point
NOTE: Perform this operation with warm engine,
to get a better fluidity of the oil and get
a full discharge of oil and impurities
contained in it.
1. Loosen the oil filler cap A (Fig. 6.1).
2. Remove the oil dipstick B.
3. Remove the oil drain plug D and the gasket E
(the oil drain plug is on both sides of the oil sump).
4. Drain oil
(For the
Par. 6.5 DISPOSAL and
5. Replace gasket E.
6. Tighten the drain oil plug D (tightening torque at 50 Nm).
7. Perform the operations from point 2 to 5 of
8. Add the type and amount of oil recommended
(Tab. 2.1 and Tab.
• Do not exceed the MAX level on the dipstick.
9. Fit and remove the oil dipstick B to check the level.
- Pour in fluid until reaching the MAX level mark.
ED0053030120 _08
Index
INFORMATION ABOUT REPLACEMENTS
Before proceeding with operation, read
•
Important
1.
in an appropriate
exhausted oil disposal,
SCRAPPING).
Par. 6.2.
2.2).
Important
Danger
Important
A
6.1
container.
refer to
6.2
6.3
Par. 3.2.2
E
D
D
C
6
B
A
29 EN