Table of Contents
Advertisement
EXCELL PRECISION CO., LTD
3-2 Linearity Calibration
After linearity calibration, it is necessary to re-calibrate the weight.
Weight calibration should be included in linearity calibration.
The first point of linearity calibration with
plastic platter or aluminum support.
AD
0
Remove all weight from the pan,
press
to enter linearity
TARE
calibration mode.
Remove the steel weigh pan, and
leave the plastic one, ensure the pan
is empty, press
TARE
the "first point".
st
Apply the 1
weight for the second
point, enter the weight factor, press
key to record the
TARE
"second point"
nd
Add 2
weight, enter the weight
factor, press
TARE
the "third point"
rd
Add 3
weight, enter the factor, press
key to record the "forth point"
TARE
th
Add 8
weight, enter weight factor,
press
key to record the "ninth
TARE
point"
02005302
The zero point with steel platter
or plastic platter.
key to record
key to record
*Weight factor
Refer to note below
ON/ZERO key ⇒ Upward key (0~9 digit entry)
UNITS key ⇒ Downward key (0~9 digit entry)
TARE key ⇒ Move cursor rightward
NET/GROSS key ⇒ Move cursor leftward
41
The last point of
linearity calibration with
plastic platter or
aluminum support.
524288
The full capacity weight with
steel platter or plastic platter.
ZSME300000237
Advertisement
Table of Contents
