Location Requirements; Turning Off The Printer - Tektronix Phaser 380 Options Manual

Installing the Printer Station

Location requirements

Before unpacking the Printer Station, prepare an area that allows appropriate clearances for proper
ventilation of the printer. Install on a level ßoor surface, allowing for no more than 1.3 cm (0.5 in.) tilt
from level across any side of the Printer Station.
Printer Station Dimensions
Height: 51.5 cm (20.25 in.)
Width: 59.7 cm (23.5 in.)
Depth: 62.2 cm (24.5 in.)

Turning off the printer

Before unpacking the Printer Station, prepare the printer to be moved by turning it off using the On/Off
switch located on the rear panel. Allow at least 45 minutes for the printer to cool before moving it.
Use the rear-panel On/Off switch to turn off the printer. This places the printhead in
1.
a safe position for moving the printer a short distance. If you are moving the printer
a long distance, remove the maintenance tray and lock the printhead transit
restraint. Refer to the printerÕs user manual for more information.
Caution
After turning off the printer, wait 45 minutes before moving it to allow the ink in the
printer to solidify. Failure to do so can result in ink spills that can damage the printer.
!
After the printer powers down, disconnect the power cord and other cables.
2.
If present, disconnect the Lower Paper Tray Assembly cable from the printer.
3.
Unpacking the Printer Station
Using a utility knife, cut open the Printer Station shipping box from the top to the
1.
bottom at each corner.
Warning
The Printer Station weighs 31.4 kg. (69 lbs.). Do not attempt to lift it without the
assistance of another person.
!
Lift the Printer Station from the Printer Station shipping box.
2.
Printer Clearances
Top: 45.7 cm (18 in.)
Right Side: 10.2 cm (4 in.)
Rear: 10.2 cm (4 in.)
Left Side, Front, Bottom:
no restrictions
45
Min.
2
Product Weights
Printer Station: 31.4 kg (69 lbs.)
Printer: 100 kg (220 lbs.)
Lower Paper Tray: 36.8 kg (81 lbs.)
Combined Total: 168.2 kg (370 lbs.)
2818-02