Printer Certifications - Xerox DocuPrint P1210 User Manual

P1210UG-8 6/30/00 3:59 PM Page 1.24
P R I N T E R C E R T I F I C A T I O N S
Laser Safety
The Xerox DocuPrint P1210 complies with safety standards, and is certified as a Class 1 Laser product under the U.S.
Department of Health and Human Services (DHHS) Radiation Performance Standard according to the Radiation Control
for Health and Safety Act of 1968. The printer does not emit hazardous laser radiation.The use of controls, adjustments,
or procedures other than those specified in the documentation might result in hazardous exposure to
laser light.
(European Union) Declaration of Conformance
The CE marking applied to this product symbolizes Xerox Ltd. Declaration of Conformity with the following applicable
Directives of the European Union as of the dates indicated:
January 1, 1995: Council Directive 73/23/EC amended by Council Directive 93/68/EC, on the harmonization of the laws
of the Member States related to equipment designated for use within certain voltage limits.
January 1, 1996: Council Directive 89/336/ED, approximation of the laws of the member states related to electromagnetic
compatibility. When applicable
March 9, 1999; Council Directive 99/5/EC, on the harmonization of the laws of the Member States related to radio and
telecommunications terminal equipment.
A full declaration, defining the relevant Directives and referenced standards can be obtained from your Xerox Ltd.
representative.
WARNING: Changes or modifications to this equipment not specifically approved by Xerox Europe may void the user's
authority to operate this equipment.Shielded cables must be used with this equipment to maintain compliance with the
EMC Directive (89/336/EEC).
WARNING: In order to allow this equipment to operate in proximity to Industrial, Scientific and Medical (ISM)
equipment, the external radiation from ISM equipment may have to be limited or special mitigation measures taken.
Australia and New Zealand
Changes or modifications to this equipment not specifically approved by Fuji Xerox Australia Pty. Limited may void the
user's authority to operate this equipment. Shielded cables must be used with this equipment to maintain compliance with
the Radiocommunications Act 1992.
Radio Frequency Emissions
United States and Canada
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not specially approved by Xerox Corporation may void the authority granted
by the FCC to operate this equipment. Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.In order to allow this equipment to operate in proximity to Industrial, Scientific and Medical (ISM)
equipment, the external radiation from ISM equipment may have to be limited or special migration measures taken.
1.24
U s e r G u i d e