Table of Contents
Advertisement
Poor quality copies:
Copies are faded, colors are
dull or white streaks
Repetitive patterns are visible
Paper wrinkled and very wet
Incorrect image placement on
page or edges cut off
Copies are crooked
Problems when scanning
Preview of the scanned
document does not appear
on screen.
60
Check Problems with Print in Troubleshooting
section.
on the copy
Check Problems with Print in Troubleshooting
section.
will take longer.
Make sure that the paper type selected on
the front panel display is the same as the
type of paper actually loaded in your
WorkCentre.
Press the Copy Quality button to select
better copy quality.
Press the Copy Intensity button to select
better copy intensity.
Clean the glass and/or the underside of the
copier cover with a soft, damp cloth. Some
types of originals, such as newsprint or
newspaper photos do not copy well. To
optimize quality, place a sheet of clear,
clean film on the copier glass, and then
place the original face down on top of the
film.
When material is reprinted, repetitive
patterns may be visible on the copy. Try to
eliminate the patterns by reducing the copy
size or by placing the document at an angle
on the glass.
Make sure that the paper type selected on
the LCD is the same as the type of paper
actually loaded in your WorkCentre.
Change the Paper Type setting OR load the
input tray with paper indicated by the
current setting.
Make sure the original is aligned both
horizontally and vertically with the scale at
the edge of the document glass.
The enlargement ratio currently selected is
making the copy too large or too small.
Correct the setting.
The paper size setting currently selected
does not correspond to that loaded in the
input tray. Load the correct paper size OR
change the setting.
Align the original correctly against the scale
at the edge of the document glass.
Make sure the copy or print job is complete
before scanning.
Place the original face down and align it
Advertisement
Table of Contents
