Table of Contents
Advertisement
Using your WorkCentre as a Printer
Printer Monitor features
Job Status
Click on the Job Status tab at the top of the screen to display the current
condition of the WorkCentre (printing, idle, error condition).
Printer Care tab
Click the Printer Care tab at the top of the screen, to access the following
care functions:
Ink cartridge:
Two images (one for each print cartridge)
These images give an indication of the ink level in the corresponding
cartridge. The indication given will be reliable ONLY if you pressed the "10"
button on the control panel when you inserted the new print cartridge.
Align
Click Align to print the test pages that confirm the accuracy of bi-
directional printing after replacing one/both of the print cartridge(s).
You must then follow the instructions displayed on the WorkCentre control
panel, using the control panel buttons to select/confirm the alignment
values (this feature requires at least two sheets of paper).
Clean
Click Clean before changing the print cartridge if you notice deterioration in
the print quality.
Follow the instructions displayed.
Activate dry delay time
Click Dry delay time if you are printing photographs, high-density graphics
or concentrated black texts.
This feature programs a pause between the printing of two successive
pages, allowing the first page to dry before the next page is printed. The
pause can be overridden, by pressing START on the control panel.
Print Test
Click Print test to print a page of the printer's functional characteristics
(firmware release, print cartridge tests, current settings).
Follow the instructions displayed; the print test requires at least one sheet
of paper.
(continued)
47
Advertisement
Table of Contents
