Connecting The Parallel Cable (Xe80, Xe82); Connecting The Power Cord - Xerox WorkCentre XE80 User Manual

Connecting the Parallel Cable (XE80, XE82 only)
1. Connect the IEEE-1284 parallel cable to the parallel port on the back of
the WorkCentre.
2. Connect the IEEE-1284 parallel cable to the parallel port on the back of
the PC.
Turn to the Printer Driver Software Installation section in this User
Guide to set up the WorkCentre XE for printing.

Connecting the Power Cord

As electricity is always dangerous if not used properly, please
take all necessary precautions to prevent electric shocks when
connecting and disconnecting the WorkCentre.
If you use the WorkCentre in a country other than the country
where the WorkCentre was purchased, you will need to make sure
that your local power supply is compatible with your model. If you
plug the WorkCentre into an incompatible power supply,
irreparable damage to the WorkCentre will result.
1. Check that the power switch for the WorkCentre is in the OFF position.
The switch is located on the lower left hand side of the WorkCentre and
labeled "O" for OFF and "I" for ON.
2. Connect the power cord to the power cord socket in the rear left hand
corner of the WorkCentre, and then plug the other end into a properly-
grounded power outlet.
The WorkCentre should only be plugged into a properly-grounded
wall socket. Do not plug the WorkCentre into a power strip.
3. Load paper (refer to Loading Media).
4. Turn on the power switch ON.
10