Fcc Compliance In The Usa - Xerox WorkCentre XE80 User Manual

FCC Compliance in the USA

WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a different circuit than the
receiver.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not specifically approved by the
Xerox Corporation may void the authority granted by the FCC to operate this
equipment.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Use of controls or adjustments of performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
EME Compliance in Canada
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment regulations.
ENERGY STAR (XE80 series)
As an ENERGY STAR® Partner, Xerox Corporation has
determined that this product meets the ENERGY
STAR® guidelines for energy efficiency.