Guidelines For Special Media - Xerox WorkCentre Pro 412 User Manual

Page 7-24

Guidelines for Special Media

Ensure you read any instructions that come with your special
paper. These instructions provide important information
regarding how to achieve the highest print quality with these
papers.
- It is recommended that you feed special paper types one
sheet at a time.
- Only use the special media recommended for use in laser
printers.
- To prevent special media such as transparencies and
label sheet sticking together, remove them from the exit
tray as they are printed.
- Place transparencies on a flat surface after removing
them from the product.
- Do not leave the film in the paper tray for long periods of
time. Dust and dirt may accumulate on the film resulting in
spotty printing.
- To avoid smudging caused by fingerprints, handle
transparency film and coated paper carefully.
- To avoid fading, do not expose the printed film to
prolonged sunlight.
- Store unused media flat. Do not remove papers from their
protective packaging until you are ready to use them.
- Store unused media at temperatures between 15 to 30
degrees centigrade (59 and 86 degrees fahrenheit). The
relative humidity should be between 10% and 70%.
- Do not load more than 10 sheets of special media into the
Bypass Tray at a time.
- Verify that the labels' adhesive material can tolerate
fusing temperature of 200
- Make sure that there is no exposed adhesive material
between the labels. Exposed areas can cause labels to
peel off during printing, which can cause paper jams.
Exposed adhesive can also cause damage to product
components.
° °
C (392 F) for 0.1 second.
Xerox WorkCentre Pro 412 User Guide