Toshiba MMY-MUP0961HT6P-UL Service Manual page 72

Hide thumbs Also See for MMY-MUP0961HT6P-UL:
Table of Contents

Advertisement

No.
Item
18
Louver control
• If there is the locked louver in the unit, [
(Continued)
• While the following controls are performed, the louvers
• The real louver corresponding to the louver No. displayed
19
DC motor
1) When the fan starts, positioning is performed for the
2) DC motor operates according to the command from
(Note) If the fan rotates by entry of outside air, etc while
(Note) If the fan lock was detected, the operation of the
20
Power saving
(In the case of RBC-AMT*)
mode
1.
2.
3.
4.
Outline of specifications
remote controller screen.
operate even if executing the louver lock.
Control which ignores lock
Operation stop
When heating operation started
Heating thermostat OFF
During defrost operation
Initialize operation
on the remote controller screen during setting of louver
lock operates swinging.
starter and the rotor. (Vibrate slightly)
the indoor controller.
the air conditioner stopped, the indoor unit may
operate as the fan motor stops.
indoor unit stops and the check code is displayed.
SAVE
Push the
button on the remote controller
The "
" segment lights up on the wired remote
controller display.
The requirement capacity ratio is limited to
approximately 75 %.
If the power saving operation is enabled, the settings
are retained when the operation is stopped, when the
mode is changed, or when the power is reset.
The power saving operation will be enabled at the next
time the operation starts.
• The operation may differ depending on the connected
outdoor unit. Refer to the Service Manual of the
outdoor unit.
] goes on the
Objective louver No.
Horizontal discharge position
Horizontal discharge position
Horizontal discharge position
- 72 -
Remarks
For the setting operation,
refer to [How to set louver
lock] of Installation Manual.
Full-close position
Full-close position
It is position check operation
and it does not link with the
real louver and air direction
setup (Illustration on the
remote controller screen).
Check code [P12]
Subject model :
4-way cassette
Compact 4-way
2-way cassette
1-way cassette (SH)(YH)
Floor standing

Advertisement

Table of Contents
loading

Table of Contents