Olivetti PF-P09 Service Manual page 373

20. FAX ERROR
(32) Error code: 00BD
Definition Can not detect correct V.21 or JM signal after detected FSK frequency.
Solution 1.
2.
3.
4.
(33) Error code: 00BF
Definition Capability no match.
Solution 1.
2.
(34) Error code: 00C0
Definition Remote side disconnect before entering primary channel in V.34.
Solution 1.
2.
3.
4.
(35) Error code: 00C1
Definition At phase D, transmitting units out EOP 3 times consecutively, but receive no answer
from receiving unit.
Solution 1.
2.
3.
4.
(36) Error code: 00C2
Definition Remote side disconnect after sending out V.8 CM signal.
Solution 1.
2.
3.
4.
(37) Error code: 00C4
Definition After sending MPS signal, the received is not one of MCF, RTN, PIP, PIN, RTP, DCN.
Solution 1.
2.
330
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Boost the TX level of sender's machine.
Change the machine TX speed to V.17, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Change the machine TX speed to V.17, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Resend the FAX again.
Change the machine TX speed to V.17, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Resend the FAX again.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Set SOFT SW21 [5] to "1" (T4 timer = 4.5 sec.)
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Check the line condition whether is too noisy, if necessary, please replace a new
telephone line or contact your telecom service provider.
Resend the FAX again.
Change the machine TX speed to V.17, then resend again.
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Set SOFT SW21 [5] to "1" (T4 timer = 4.5 sec.)
Print out the protocol report, and provide it to technical center, ask for analyzing
the information.
Field Service Ver. 1.1 May 2011