Table of Contents
Advertisement
DSA E-Series (E2700)
6.
7.
8.
9.
10. Install the drive trays.
Bosch Sicherheitssysteme GmbH
With the help of one other person, slide the rear of the controller-drive tray onto the
mounting rails. The rear edge of the controller-drive tray must fit into the clip on the
mounting rail. The controller-drive tray is correctly aligned when these conditions are
met:
–
The mounting holes on the front flanges of the controller-drive tray align with the
mounting holes on the front of the mounting rails. Refer to item 4 in the following
figure.
–
The rear edge of the controller-drive tray sheet metal fits into the clip on the
mounting rail.
–
The holes in the controller-drive tray sheet metal for the rear hold-down screws align
with the captured nuts in the side of the mounting rails.
1
2
1 - Mounting rail
2 - Clip
3 - Partial view of the controller-drive tray rear sheet metal
4 - Mounting holes
Secure the front of the controller-drive tray to the cabinet. Use the two screws to attach
the flange on each side of the front of the controller-drive tray to the mounting rails.
–
Insert one M5 screw through the bottom hole of a flange on the controller-drive tray
so that the screw goes through the cabinet rail and engages the bottom captured nut
in the mounting rail. Tighten the screw.
–
Repeat substep a for the second flange.
Note: The rear of the controller-drive tray contains two controllers. The top of the
controller-drive tray is the side with the labels.
Secure the side of the controller-drive tray to the mounting rails by performing these
substeps:
–
Insert one M4 screw through the side sheet metal of the controller-drive tray into the
captured nut on the side of the mounting rail. Tighten the screw.
–
Repeat substep a for the other side.
Attach the plastic end caps onto the front of the controller-drive tray.
–
Put the top of the end cap on the hinge tab that is part of the controller-drive tray
mounting flange.
–
Gently press on the bottom of the end cap until it snaps into place over the retainer
on the bottom of the controller-drive tray mounting flange.
Installing the E2700 controller-drive tray | en
4
3
78039-01
Installation manual
25
2016.12 | V2.1 | DOC
Advertisement
Table of Contents
