Table of Contents
Advertisement
24
en | Installing the E2700 controller-drive tray
5.
2016.12 | V2.1 | DOC
Note: Risk of equipment malfunction - To avoid exceeding the functional and
environmental limits, install only drives that have been provided or approved by the
original manufacturer. Not all controller-drive trays or drive trays are shipped with pre-
populated drives. System integrators, resellers, system administrators, or users of the
controller-drive tray or drive tray can install the drives.
Attach the mounting rails to the cabinet.
–
Make sure that the adjustment screws on the mounting rail are loose so that the
mounting rail can extend or contract as needed.
1
3
1 - Cabinet mounting holes
2 - Adjustment screws for locking the mounting rail length
3 - Mounting rails
4 - Clip for securing the rear of the controller-drive tray
–
Place the mounting rail inside the cabinet, and extend the mounting rail until the
flanges on the mounting rail touch the inside of the cabinet.
–
Make sure that the alignment spacers on the front flange of the mounting rail fit into
the mounting holes in the cabinet.
The front flange of each mounting rail has two alignment spacers. The alignment
spacers are designed to fit into the mounting holes in the cabinet. The alignment
spacers help position and hold the mounting rail.
1 - Alignment spacers
–
Insert one M5 screw through the front of the cabinet and into the top captured nut
in the mounting rail. Tighten the screw.
–
Insert two M5 screws through the rear of the cabinet and into the captured nuts in
the rear flange in the mounting rail. Tighten the screws.
–
Tighten the adjustment screws on the mounting rail.
–
Repeat the substeps to install the second mounting rail.
2
4
78039-03
78039-04
1
Installation manual
DSA E-Series (E2700)
1
Bosch Sicherheitssysteme GmbH
Advertisement
Table of Contents
