Power Saver; Scanner Control - Xerox 6030 User Manual

POWER SAVER

SCANNER CONTROL

XEROX WIDE FORMAT COPY SYSTEM
The POWER SAVER option of the CONFIGURATION menu allows you
to set the number of hours of inactivity after which the system goes into
Power Saver mode.
To adjust the power saver:
1. Press the Menu key. The MAIN MENU screen is displayed.
2. Press the Enter key to select CONFIGURATION. The
CONFIGURATION menu screen is displayed.
3. Press the Next key until POWER SAVER is highlighted.
4. Press the Enter key to select POWER SAVER. The POWER
SAVER screen is displayed.
POWER SAVER DELA Y (0 − 4 HR): 3
5. Use the numeric keypad to enter the power saver value. The
valid value range is 0 to 4 hours. The factory default is 3 hours.
6. Press the Enter key to confirm the value.
7. Press the Exit key to return to the CONFIGURATION menu
screen.
The SCANNER CONTROL option of the CONFIGURATION menu allows
you to set the options for how the Scan System starts and finishes a
scan. It contains the following features:
•
AUTOSCAN - Tells the Scan System either to start the scan
automatically when the document is inserted (ENABLED), or to
wait until the Start key is pressed (DISABLED). ENABLED is
the factory default setting.
•
DOCUMENT RETURN - Tells the Scan System, after the scan,
either to return the document to the front of the Scan System
(FRONT), or to drop the document from the rear of the Scan
System into the catch tray (REAR). REAR is the factory default
setting.
NOTE: Refer to Controlling the Scan for additional information.
MODE: (PRODUCTIVITY is the default.)
•
MANUAL WIDTH - The user must enter the document width
and very carefully center the document. In this mode the
document will be prescanned.
•
AUTOWIDTH - Enables the automatic detection of the width
of the document. In this mode the document will be
prescanned.
POWER SAVER
Power Saver Screen
Main Menu • 107