Table of Contents
Advertisement
Laser Guide
The laser should be checked and adjusted before
starting a new project, and any time you raise or
lower the table, or change workpiece thickness.
DO NOT look directly into laser. Severe eye
injury will result.
To adjust laser:
1.
DISCONNECT
DRILL
POWER!
2.
Install drill bit in chuck (see Installing/
Removing Drill Bits on Page 25 of Model
G7944 manual).
3.
Clamp workpiece securely to table.
4.
Adjust table so workpiece is within range of
drill bit, then lock table in horizontal position.
5.
Lower drill bit so it touches workpiece, mak-
ing a slight indentation in the surface, then
raise bit.
6.
Connect drill press to power. Turn laser
ON using switch on front of drill press (see
Figure 1).
Laser ON/
OFF Switch
Figure 1. Location of laser ON/OFF switch.
-4-
PRESS
FROM
7.
Adjust laser (Figure 2), positioning it by hand
so crosshairs align with indentation you made
earlier in surface of workpiece, as shown in
Figure 3.
Figure 2. Location of laser.
Indentation
Figure 3. Crosshairs aligned with indentation on
workpiece.
Model G0794 (Mfd. Since 05/18)
Advertisement
Table of Contents
